This is an old revision of the document!
The Advanced Installer was forked from the Remastersys Installer a few years ago, to provide a lightweight system installer.
The Advanced Installer is preinstalled as default, alongside the main (default) Sparky Installer (aka 'live-installer') to provide:
1. A backup installer to the main one;
2. A lightweight installer to older machines, which can't run the Python based 'live-installer';
3. An additional funcionality which let you install one of many desktops of your choice (MinimalISO only);
It works in two modes of your choice:
1. Graphical mode, the Yad based - runs from system's menu→ System→ Sparky (Advanced) Installer
or via the command line:
sudo sparkylinux-installer gui
2. Text mode, the Dialog based, runs via the command:
Make sure that the Advanced Installer needs a little more your attention than the Live Installer.
1.The first Advanced Installer window asks you about confirming your decision - do you like to install Sparky or not.
2. The Installer installs the live system with en_US locales as default. To change it, choose *Yes*.
3. Now, you have to choose a disk (hard or flash) to install the system too.
4. After choosing a disk, you can divide/split existing partitions. make sure you need at least:
- one root partition for system files (10-20 GB about)
- one swap partition (500MB - 1GB about)
- one efi partition (100-300MB about) (UEFI machines only)
- one home partition for your private files (optional)
If you would like to set a home directory (the next step) on separated, shared partition, DO NOT use the same user nick name as already exist in the other Linux distribution you will be sharing the home directory with. If you deleted other Linux distribution before and there still exist your old home directory - DO NOT use the same nick name as you had before.
The new nick name has to be different the before so the home directory will get different name, so it will evoid problems after the first hard drive booting.
If you are not sure about the partitioning process, read Disk partitioning guide.
5. After disk partitioning to be finished, choose your partition for *efi.image* to be installed to (EFI machines only). If the partition already exist on your machine (other operating system/systems already installed), don't format it, just use it.
6. Choose the swap partition.
7. Choose the root partition.
Than choose other partitions if any (home, boot, proc, media, etc.)
8. Choose a file system to be used to the root partition (ext4 prefered).
9. Choose your home partition if you have a one. If not, the home folder will be installed inside the root partition.
10. Type informations about your account and the machine:
11. Choose a place to install GRUB bootloader to: